Diamond crown drill 2180 W with stand [CLONE] [CLONE] [CLONE]

General description of the 2180 W diamond crown drill with stand

With a strong and robust crown drill with a stand, we can drill into vibrated concrete, reinforced concrete (reinforced concrete), rocks, rocks, concrete and brick walls, concrete slabs, screeds, asphalt and concrete coatings, concrete and stone scarps, etc.

The drill for diamond crown drilling is used for drilling holes (holes), channels and grooves up to a maximum diameter of Ø 160 mm for electrical and heating heating, sewerage, plumbing and drainage systems ...

The Korn drill is mounted on a stand via a toothed stepless guide

During drilling into harder materials, cooling of the drill bit is enabled via a connected hose. Cooling extends the life of the crown drill and results in faster and easier drilling due to water lubrication of the drill bit and the removal of any dust from the well. , A ball valve for water supply is attached to the drill. The ball valve has a standard fitting for quick connection of the garden hose on the connection part.

The drill for crown drills can be used outdoors, on construction sites and indoors. A highly resistant metal housing is adapted to this.

The diamond drill bit can be mounted on the crown drill by screwing on a 1 ¼ '' (inch - inch - inch) threaded head. The crown drill is self-tightening during installation, as the screwing direction (screwing - screwing) is the opposite of the drilling direction during installation. Unscrewing (unscrewing - unscrewing) of the crown drill bit during drilling is therefore not possible. Appropriate tools are included to make it easier to replace the crown drill bit.

There is a disconnecting electrical switch on the electrical connection cable completely separate from the crown drill, which disconnects the crown drill from the mains in the event of an overload and continuously maintains the voltage in the rest of the mains. The release switch has a built-in reset position switch, which indicates overload to the user in the event of an automatic shut-off of the drill with its pop-up function. There is also a switch button on the switch to check the cause of the overload on the crown drill. If the overload is eliminated, the crown drill is switched on again when pressed, or it is not switched on if the overload is not eliminated.

Properties

Water connection with hose about 4 meters
Overload protection / slip clutch
Aluminum bracket
Use from -25 ° C.
Drill Ø 10.8 cm / 35 cm long
1/2 "BSP threaded connection for drills
55 mm pin on the stand for quick release
No-load speed 1600 rpm
Rated input power 2180W
A cage without a water seal reduces maintenance costs
The aluminum alloy material is lighter and more stable
Maximum drilling diameter 160 mm
Suitable for sampling concrete, cement, brick, asphalt and block

Package contents

1 x diamond tip
1 x drill bit (Φ108 mm)
1 x ring wrench
1 x key
1 x pipe
1 x hand pump
5 x expansion bolts
2 x carbon brushes