Plasma cutter inverter 40 A
Please sign in so that we can notify you about a reply
Cutting current range
20 ~ 40 А.
Input power
4.7 kVA
Maximum cutting thickness in steel
12 mm
Cutting current setting
With a rotating stepless knob with which we can mine and take the current depending on the needs of plasma cutting. The button also has support for cutting built-in some orientation values.
Orientation values of the cutting current shown on the stepless knob
20 A, 21 A, 22.5 A, 25 A, 28 A, 30 A, 32.5 A, 35 A, 37.5 A, 40 A
Power factor
0.93
Tension in natural teak
220V
Compressor pressure required to operate the plasma cutter
Approx. 4.5 bar (compressor not fully included)
The outlet air flow from the compression is required to operate the plasma cutter
120 L / min (compressor and included set)
Rated output current
40 А.
Rated output voltage at cutting
96 В.
Constant load without overheating during cutting (duty cycle)
60%
Ignition
High frequency (HF)
Resol also plasma
9 kg
Burner with start and end plasma cutting button
Yes
Electrodes Number completed
3.
Number of white ceramic gas rectifiers perfect
1.
Number of white ceramic heat shields in the kit
1.
Trigger cable for turning the plasma cut on and off
Yes
Plasma gas supply pressure hose
Yes
Rubber lining connecting the trigger cable and the supply pressure hose
Yes
The valley of the trigger cable in the supply pipes to which the burner is connected
Approximately 380 cm
Gorilnik Valley
About 20 cm
Total burner and hose length (trigger cable in supply pressure hose)
Approximately 400 cm
Ground cable with receiver (earthing)
Yes
Valley of the cable for the ground on which the receiver is attached
Approximately 240 cm
Receiver length
About 20 cm
Total length of ground cable with receiver (earthing)
Approximately 260 cm
Flow air regulator with manometers that allows even air pressure from the compressor by cutting
Yes
Flow air regulator with built-in filters in dehumidifiers for dry and clean air from the compressor by cutting
Yes
The mounting bracket regulates the air flow on the plasma cutter
Yes
Number of clamps to attach the gas pipes to the perfect
2.
Number of adapters for connecting gas pipes to the air regulator or. From the plasma cutter
3.
Wire brush
Yes
Welding shield (welding mask)
Yes
Transport handle
Yes
Fan forced cooling
Yes
Thermostatic thermal protection
Yes
Voltage
230 V, 50 Hz single-phase AC electrical voltage
Weight
11,5 kg
Mere paketa
371 x 155 x 295 mm
Warranty
12 mesecev
No reviews found