Submersible deep well monoblock pump 40 l/min 75 m 550 W 100 mm 230 V

100 mm deep well displacement pumps. The pump is mainly made of stainless steel, e.g. housing, bolts, inlet/outlet and rotor. Depending on the customer’s requirements, the pump is equipped with 20 m power cables. Due to the capacitor built into the motor, the pump is ready for installation immediately after unpacking. The pump is equipped with thermal protection mounted in the motor winding.The pumps are recognized by customers for their robust design and attractive price.

APPLICATION:

Supply of water to single-family houses and holiday houses.

OPERATING CONDITIONS:

• Maximum liquid temperature 40°C
• Maximum ambient temperature 40°C
• Class B Insulation
• Operating mode - continuous
• Protection - IP68

MATERIALS:

• Housing: stainless steel AISI 304
• Shaft and rotor: stainless steel AISI 304
• Screw: stainless steel AISI 304
• Stator: NBR
• Motor: oil cooling
• Mechanical seal: ceramics/Sic
• Rotational speed of the electric motor: 2850 rmp

Voltage

Electric motor (230 V / 50 Hz single-phase alternating voltage AC)

Power

550 W

Weight

12 kg

Warranty

12 months

Amperage

3,4 A

Fluid flow rate (maximum pumping speed)

40 liters per minute

Immersion depth (max.)

75 m

Flow

2400 l/h = 40 l/min

Pressure

7,5 bar

Diameter

Ø 100 mm

Pump dimensions

(Ø 100 x 570) mm

Diameter of the outlet pressure pipe connection on the electric pipe submersible pump

Nominal diameter Ø 25 mm (1 inch - 1" - 1 inch), according to standard DIN 2440:1978-06;

Dimensions

(540 x 115 x 230) mm

Connection

25 Ø mm (1 inch - 1" - 1 1/2 inch)

Diameter of the outer casing of the electric submersible pump

Ø 100 mm

Length of electric cable

20 m

The diameter of the outer casing of the electric submersible pump in inches

4"

Bore diameter required to insert electric submersible pump

Ø 110 mm

Housing type

Stainless steel AISI 304

Shaft and rotor

Stainless steel AISI 304

Screw

Stainless steel AISI 304

Motor

Oil cooling

Protection class

IP68

Class

B Insulation

Operating mode

Continuous

Lubrication

Is not necessary

Outer casing made of stainless steel submersible part of electric submersible pipe pump

Yes

Quick and easy installation of a submersible drainage sump pump

Yes

Airtight seal of the electric motor of the submersible drainage sump pump

Yes

Additional connection with external thread for screwing to the submersible pump on one side and ribbed relief for a firmer connection to the pressure or suction pipe with a clamp on the other side of the connection

Yes

Two steel lugs for easy connection of steel rope or chain for easy raising and lowering of the submersible pump from and into the well

Yes

Suitability of a submersible drainage sump pump for operation in hydrophore systems

Yes

Find similar

fdsfds

No reviews found