Diamond crown drill 2400 W with stand

General description of a 2400 W diamond crown drill with stand

With a strong and robust crown drill with a stand, we can drill into vibrated concrete, reinforced concrete (reinforced concrete), rocks, rocks, concrete and brick walls, concrete slabs, screeds, asphalt and concrete coatings, concrete and stone scarps, etc.

The drill for diamond crown drilling is used for drilling holes (holes), channels and grooves up to a maximum diameter of Ø 205 mm for electrical and heating heating, sewerage, plumbing and drainage systems ...

The Korn drill is mounted on a stand via a toothed stepless guide

During drilling into harder materials, cooling of the drill bit is enabled via a connected hose. Cooling extends the life of the crown drill and results in faster and easier drilling due to water lubrication of the drill bit and the removal of any dust from the well. The 52 cm flexible hose has a ball valve attached at hand, with the possibility of interrupting the water supply. As a result, there is no need to delay the supply of water to the water supply network. The ball valve has a standard attachment for quick attachment of the garden hose on the connection part, with which an additional supply hose is connected manually without additional tools.

The drill for crown drills can be used outdoors, on construction sites and indoors. The high-resistance metal housing is adapted to this, which is resistant to objects larger than 12.5 mm according to the stated IP20 degree of protection CEI 70-1 (EN60529).

The diamond drill bit can be mounted on the crown drill by screwing on a 1 ¼ '' (inch - inch - inch) threaded head. The crown drill is self-tightening during installation, as the screwing direction (screwing - screwing) is the opposite of the drilling direction during installation. Unscrewing (unscrewing - unscrewing) of the crown drill bit during drilling is therefore not possible. To make it easier to replace the crown drill, the drill head can be held in place with a 36 mm open-end wrench, which is included in the kit in addition to the 32, 27 and 24 mm open-end wrenches.

There is a disconnect current switch (FID counter) on the 230 cm electrical connection cable completely separate from the crown drill. The current switch automatically disconnects the crown drill from the mains in the event of an overload and continuously maintains the voltage in the rest of the mains. The release switch has a built-in reset position switch, which signals the user an overload in the event of the drill being switched off automatically with its pop-up function. There is also a switch button on the FID switch to check (cause) the cause of the overload on the crown drill. If the overload is eliminated, the crown drill is switched on again when pressed, or it is not switched on if the overload is not eliminated.